#How to do a ledger board on brick house how to#
#How to do a ledger board on brick house install#

Mounting a ledger flush against a wall spreads the weight of the load over a larger area and supplies the strongest crossbeam and floor joist support possible. Whether youвЂ™re attaching a pergola or a covered deck to a brick wall on one side of your house, never underestimate the importance of installing the load-bearing ledger boards correctly.

#How to do a ledger board on brick house how to#

Today Im showing you how to attach a deck to a house (safely). Building a deck can add to the monetary value of your home as well as to your enjoyment of it, whether you host parties or sample the beauty of nature from it.

#How to do a ledger board on brick house install#

Calculate the length as 3 inches less than the width of the deck framing.Дo you put a ledger Board on a brick wall? One of the most common questions is how to install a ledger board for a deck and today, I am. You can use a larger board, however, if it allows for a better connection to the house framing. What size should a deck ledger board be?ДЄs a general rule, you should use the same size of board for the ledger as you plan to use for the joists. Enlarge the two end supporting holes by drilling into them again with a masonry drill bit the same diameter as your lag bolt anchors. Repeat this on the other side and voila!Дrill two 6 mm (1/4 inch) pilot holes through the upper pilot holes on each end of the ledger and into the brick behind with a masonry drill bit. Drive the anchor into the pre-drilled hole until the head is flush with the mounting bracket (or the wood itself). Using a nut driver on the hammer drill, put the anchor in place. Place your mounting bracket or other mount of choice against the wall, over the pre-drilled hole. Calculate the length as 3 inches less than the width of the deck framing. You can install them in seconds and most importantly: no holes to drill. They are removable, adhesive-free, and strong (holds up to 25 lbs).

The only prescriptive option the code provides for building a deck on a house with stone or masonry veneer is to construct it to be self-supporting. These hooks are designed for brick walls, even slightly curved ones. Two sections of the 2018 IRC (R507.9.1.1, R703.8.3) prohibit attaching a deck ledger to the masonry or stone veneer cladding a house. The best way to attach wood to brick without drilling is to use a brick wall hook.